Downloading system image file from flsh of AP

Follow these steps to delete the current configuration and return all wireless device settings to the factory defaults using the web browser interface:. Step 1 Open your Internet browser. You must use Microsoft Internet Explorer version 5.

Step 2 Enter the wireless device's IP address in the browser address line and press Enter. An Enter Network Password screen appears. Step 3 Enter your username in the User Name field. Step 4 Enter the wireless device password in the Password field and press Enter. The Summary Status page appears. Step 7 Click the Reset to Defaults button. Step 8 After the wireless device reboots, you must reconfigure the wireless device by using the Web-browser interface or the CLI. You can obtain the wireless device image file from the Cisco.

Step 2 Find the wireless device firmware and utilities section and click on the link for the , , or series wireless device. Step 3 Double-click the latest firmware image file, such as ck9w7-tar.

JA for series access points or ck9w7-tar. There are no specific configuration requirements for this setup as long as the AP is able to register to the WLC. As you can see, there are two images that exist on the AP. One is the recovery image that comes with the AP from factory and the other is the downloaded image from the WLC to which it is registered to. Another point to keep in mind is that the majority of the disk space is used by the recovery and the downloaded images.

From WLC view, it all looks like the pre-image download went successful. So what just happened here? It looks like the original image got replaced with the secondary image in flash. If you think you are a person of immense patience, you must try it to pass a litmus test.

Just like others, it also offers slow Samsung firmware download for free. My downloading experience with SamFrew was better than all other websites listed above. When you are done with downloading the firmware for your Samsung Galaxy device, you can install it easily and safely by following the quick steps described below:. Download or Odin Mode. Why should we pay for downloading something from a 3rd-party website when we can download it directly from Samsung FUS Firmware Update Server?

In this Article click to see. Why Download Samsung Firmware? Where can You Download Samsung Firmware? SamFirm Firmware Downloader. Read more. If the image check locates a new version of the Instant software on the image server, the New version available link is displayed on the Instant main window.

If AirWave is configured, the automatic image check is disabled. To check for a new version on the image server in the cloud:.

No new version available—If there is no new version available. Image server timed out—Connection or session between the image server and the Instant AP is timed out. Image server failure—If the image server does not respond. A new image version found—If a new image version is found. The Instant AP downloads the image from the server, saves it to flash, and reboots.

Depending on the progress and success of the upgrade, one of the following messages is displayed:. Upgrading—While image upgrading is in progress. Upgrade successful—When the upgrade is successful. Upgrade failed—When the upgrade fails.

If the upgrade fails and an error message is displayed, retry upgrading the Instant AP. The following procedure describes how to manually check for a new firmware image version and obtain an image file:. Select the Image file option. This method is only available for single-class Instant AP s.